Drive Shaft Removal - Mercedes-Benz 963 2022 Series Manual

Drive shaft removal

Removing the rear axle drive shafts
i
Lock differential with screws to secure sliding sleeve
before removing drive shafts of rear axle. Problems
could otherwise arise when the drive shaft is
reinstalled.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Lock differential with screw:
• Remove electrical connector (1) from shift cylinder cover (2).
• Unscrew sensor with box wrench (SW 27 mm).
• Carefully screw screw (3) all the way into shift cylinder housing.
M18x1.5x80
For special tools, see chapter "Tools and Accessories".
• If the screw (3) cannot be completely screwed in: Pull drive shaft out
approx. 100 mm and turn until screw (3) can be completely screwed in.
Removing the rear axle drive shafts:
• Pull ignition key out of key slot.
• Lock the differential with a bolt.
• Unscrew screws (1) on wheel hubs.
• Place oil pan under wheel hub.
• Collect escaping oil in a suitable container.
• Pull out both drive shafts.
• Protect wheel hub against soiling by using a cap, see chapter "Tools and
Accessories".
• Refill with oil.
68 Actros, Antos and Arocs | Towing and recovery
W35.40-A006-71
W35.40-A005-71
W35.30-A024-71