Table of Contents
Advertisement
Care of Your Light & Easy™ Steam Mop
fig. 4
fig. 5
CARE OF YOUR MICRO-FIBER
CLEANING PAD
1
Wash pads in warm water. Wash
separately from other laundry. Only
use liquid detergent (no powder
detergent). Do not use fabric
softeners. Line dry or dry on a low
dryer setting. (fig. 5)
2
If there are loose threads on the
pad carefully cut the threads with
scissors. Do not pull on them or cut
at the base. (fig. 6)
IMPORTANT: The micro-fiber
cleaning pad may be very hot
from the steam. Use caution when
removing. Let the unit cool for 2-3
minutes.
10
TOLL FREE: 1-800-418-0934
S3250CW_11_IB_ENG_100913.indd 10-11
ORDERING REPLACEMENT PARTS
To order additional parts and
accessories, feel free to contact us at
www.sharkclean.com or call
1-800-418-0934.
NOTE: Some parts may be available
at your local retailer. Contact customer
service for any other servicing.
Trouble Shooting
PROBLEM
POSSIBLE REASONS & SOLUTIONS
Your steam-mop should be securely plugged into a
The Light & Easy™
120V AC electrical outlet only.
Steam Mop will not
Check your fuse or breaker.
turn-on.
If your unit still does not work, call 1-800-418-0934.
Light & Easy™
Is there water in the water tank? If not, add water to your
Steam Mop will not
Steam Mop following instructions on page 5.
make steam.
Light & Easy™
Is your micro-fiber cleaning pad too wet? Unplug your
Steam Mop leaves
Steam Mop and change the micro-fiber cleaning pad.
water on the floor.
Do not leave your steam-mop on the floor with a damp or
Light & Easy™
wet cleaning pad.
Steam Mop left
Do you have hard water? If you do, you might want to
white spot on the
switch to distilled water.
floor.
Make sure the water is securely on the water tank.
The pad might be dirty, change the pad.
If you washed the pocket with powder detergent, then the
pad may have residual detergent left on it. Wash it again
with liquid detergent.
If you are cleaning in a kitchen area where there might be a
build-up of grease, use a de-greasing agent such as an all-
Floors are cloudy,
purpose cleaner or dish soap and paper towels to clean the
streaky or spotty
area first.
after steaming.
You might have left the mop in the same spot for too long.
Do you have hard water? If you do, you might want to
switch to distilled water.
This might be leftover from past cleaners used on the floor
surface. Use the steam mop a few more times and see if
the leftover cloudiness is removed.
Light & Easy™
Make sure the steam pad is attached correctly.
Steam Mop is hard
Check to see if the cleaning pad is excessively dirty.
to push.
Replace if the pad is too dirty or wet.
English
www.sharkclean.com
11
10-09-13 10:57 AM
Advertisement
Table of Contents
