Trouble Shooting - Shark Steam Lite S3250UKJR Owner's Manual

Trouble Shooting

PROBLEM
The Shark Steam
®
Lite steam mop will
not turn-on.
Shark Steam Lite
®
steam mop will not
make steam.
Shark Steam Lite
®
steam mop leaves
water on the floor.
Shark Steam Lite
®
steam mop left
white spot on the
floor.
Floors are cloudy,
streaky or spotty
after steaming.
Shark Steam Lite
®
steam mop is hard
to push.
12
www.sharkclean.co.uk
POSSIBLE REASONS & SOLUTIONS
Your steam-mop should be securely plugged into a
220-240V electrical outlet only.
Check your fuse or breaker.
Is there water in the water tank? If not, add water to your
Steam Mop following instructions on page 5.
Is your microfibre cleaning pad too wet? Unplug your
Steam Mop and change the microfibre cleaning pad.
Do not leave your steam-mop on the floor with a damp or
wet cleaning pad.
Do you have hard water? If you do, you might want to
switch to distilled water.
Make sure the water is securely on the water tank.
The pad might be dirty, change the pad.
If you washed the pocket with powder detergent, then the
pad may have residual detergent left on it. Wash it again
with liquid detergent.
If you are cleaning in a kitchen area where there might be a
build-up of grease, use a de-greasing agent such as an all-
purpose cleaner or dish soap and paper towels to clean the
area first.
You might have left the mop in the same spot for too long.
Do you have hard water? If you do, you might want to
switch to distilled water.
This might be leftover from past cleaners used on the floor
surface. Use the steam mop a few more times and see if
the leftover cloudiness is removed.
Make sure the steam pad is attached correctly.
Check to see if the cleaning pad is excessively dirty.
Replace if the pad is too dirty or wet.
If your unit still doesn't work, give us a call
Freephone 0800 781 7831.