Auto Shut Off; Water Hardness Setting - Singer SISS2280 User Manual

AUTO SHUT-OFF
The auto shut off mode will activate if the steam button not press over
10 minutes whether you are using the appliance. The LCD display back
light goes off with a beep sound and the pause icon will blink. When this
occurs, press the Power ON/OFF button or steam knob once, the
appliance will switch ON immediately. Wait about one and half minutes
for the appliance to heat up to the temperature set before.

WATER HARDNESS SETTING

1. Unwind and straighten the power cord and supply cord.
2. Connect the appliance to a suitable mains supply outlet.
3. "Beep" sound would be heard and the LCD would display all logos for a
Second then turn off.
4. Press the power On/Off button
5. The medium steam level (
will display in the LCD with a beep sound.
6. The icon will blink to indicate; the steam station is heating up or cooling
down for the steam ironing.
7. Press once the water hardness setting button, the
LCD with a beep sound
8. Select your usage water hardness by press the "-, +" LCD control buttons;
Soft water (
sound would be heard for each pressing.
9. For the memory setting simply once press the water hardness setting button,
the icon will disappear from the LCD with a beep sound.
SPRAYING
This function can be used any time and is not affect any setting.
1. Remove the spray button as per fig 5
2. Fill the water tank as per fig 6
3. Replace the water tank in its place.
4. Aim the nozzle to the garment. Press the Spray Button.
Note: It may be necessary to press the spray button a few times to start this function.
) and (
) or Hard water (
) hard water level indicators
icon will display in the
) or Very Hard water (
Page 9 of 12
), a beep