Table of Contents
Advertisement
HOW TO CLEAN THE
IRONING STATION
To extend the life of your steam station and to avoid a build up of scale, it is essential
that you rinse out the boiler, after the
1. The
icon will blink to indicate you to clean the boiler.
2. Press the Power On/ off switch, the base console will switch to "Standby mode"
with a beep sound.
3. Disconnect the power cord from mains supply outlet.
4. Allow the appliance cool down fully.
5. Turn the steam station upside down and pull back the boiler cap cover as Fig 7.
6. Unscrew the boiler cap by using the provided key and empty out any water as fig 8
and Fig 9
7. Pour one cup of tap or filtered water through the boiler underneath hole as Fig 10
8. Shake the appliance gently then empty out all the water as Fig 9
9. Repeat the step 7 &8 until the water from boiler comes out clear and clean.
10. Pour 100ml water into the boiler through the boiler underneath hole as Fig 10
11. Screw the boiler cap back on again without using any excessive force as Fig 11
12. Replace the boiler cap cover.
13. The unit is now ready to use.
Fig 5
icon start to flash on the LCD.
Page 10 of 12
Fig 6
STEAM
Advertisement
Table of Contents
