Operating Instructions - Schumacher SE-1010-2 Owner's Manual

Charge Rate Selector Switch (Voltage/Amp Selector)
Use this switch to set the maximum charge rate to one of the following.
• 2A Slow Charge Rate
commonly used in garden tractors, snow mobiles and motorcycles. The 2A
rate can be used to warm or trickle charge larger batteries.
• 6A, 10A, 12A, 15A Fast and 30A Rapid Charge Rate
automotive, marine and deep-cycle batteries. Not intended for industrial
applications.
• Engine Start
or run down battery. Always use in combination with a battery.
Voltage Selector Switch
Use this switch to set the charger to charge a 6 volt, 12 volt or 24 volt battery.
NOTE: These chargers are not recommended for 8 or 16 volt systems.
LED Indicators
• Full Charge
and the charger has stopped charging and switched to the Maintain Mode of
operation (Automatic chargers only).
Power On
•
the battery charger.
• Check Battery
the battery. Check the DC connections for an improper connection; otherwise
the battery may be bad.
11.

OPERATING INSTRUCTIONS

Overview
1. Connect the battery following the precautions listed in Sections 6 and 7.
2. Select the appropriate settings for your battery.
3. Connect the AC power following the precautions listed in Section 8.
Automatic Charging
If the charger has an Automatic Charge Mode, it can perform an automatic
charge. When an Automatic Charge is performed, the charger switches to the
Maintain Mode (see below) automatically after the battery is charged. For a
battery with a starting voltage under 1 volt, use the Manual Mode first to pre-
charge the battery for five minutes to get additional voltage into the battery for
the charger to analyze.
Manual Charging
If the charger does not have an Automatic Charge Mode, you will be charging
in Manual Mode. A manual charger will continue to charge and will not shut off.
You must keep a visual check on the ammeter to determine when the battery is
charged. Be sure to monitor the charging process and stop it when the battery
is charged. Not doing so may cause damage to your battery or result in other
property damage or personal injury.
Completion of Charge (Automatic Chargers Only)
When the FULL CHARGE (green) LED is lit, the charger has stopped charging
and switched to the Maintain Mode of operation. If the 12V DEEP CYCLE
battery type was selected, the CHARGED (green) LED comes on when the
battery is charged enough for normal use.
– Intended for charging small batteries such as those
– Provides additional amps for cranking an engine with a weak
– When lit, this LED indicates that the battery is fully charged
– When lit, this LED indicates that there is AC power supplied to
– When lit, this LED indicates there is something wrong with
8
• •
– Use for charging