Assembly Instructions; Mounting Instructions - Schumacher 00-99-000940-0110 Owner's Manual

NOTE: Pursuant to Canadian Regulations, use of an adapter plug is not
allowed in Canada. Use of an adapter plug in the United States is not
recommended.
8.2 Recommended minimum AWG size for extension cord:
• 100 feet long or less - use an 14 gauge extension cord.
• Over 100 feet long - use a 12 gauge extension cord.
9.

ASSEMBLY INSTRUCTIONS

No assembly required
10.

MOUNTING INSTRUCTIONS

To mount the charger to a wall or other flat surface:
10.1 Remove the two screws from one side of the unit near the back.
10.2 Attach a mounting bracket, with the keyhole towards the top, using the screws
you just removed.
10.3 Repeat for the other side. Note: Completely install one bracket before moving
to the next.
10.4 Using the charger as a template, install two #10 panhead screw anchors (or
equivalent) into the wall you want to mount the charger to. Leave the heads
of the screws extended 1/16" away from the surface. The mounting brackets
are designed to match the 16" wall stud spacing commonly found in wood and
steel framed buildings, for increased support install the anchors into the wall
studs. NOTE: Make sure the screw/anchor combination installed into the wall
is able to support up to fifty pounds of weight.
10.5 Position the charger, with the mounting brackets installed, so that the keyhole
slots on the mounting brackets line up with both screws you installed. Then
slide the charger down so that the screw heads lock in the keyhole slot of the
mounting brackets.
6
• •