Initial Setup; Assign Network Interfaces; Set Static Ip Addresses - Crestron Automate VX Series Product Manual

Initial Setup

Use the following procedures to set up the Automate VX system following installation.

Assign Network Interfaces

The Automate VX system has two NICs labeled Ethernet and Ethernet 2. The Ethernet ports
have the following default addressing configuration:
The Ethernet port is set as a static IP for initial configuration via the VNC Viewer.
l
The Ethernet 2 port is set to use DHCP and is used for the Dante® Virtual Soundcard and
l
the Dante Controller.
Set Static IP Addresses
Static IP addresses must be set after assigning the network interfaces.
NOTE: The web interface and API of the Automate VX system rely on static IP addresses for
the system, cameras, and microphones. As a result, static IP address should be set during
initial setup.
Depending on your network configuration, either set a static IP address in the network router or
set them individually on each device. Static IP addresses can be set in the Windows Network
& Internet settings.
Windows Internet & Network Settings
Product Manual — Doc. 9324A IV-SAM-VXP-1B and IV-SAM-VXS-1B • 19