Reading The Program To Be Converted From F , And F Programmable Controllers - Mitsubishi Electric FX Series Replacement Manual

F(f1, f1j, f2)→fx3 series replacement guidance
Hide thumbs Also See for FX Series:
Table of Contents

Advertisement

2. OVERVIEW OF PROGRAM CONVERSION USING FX-20P-E
(3) With the power of the programmable controller turned off, connect FX-20P-FIM to the target
programmable controller (F
FX-20P-FIM
Connector to connect to
a programmable controller
Connector cover
(4) Turn on the programmable controller (F
"SELECT PC TYPE" window.
(5) On the "SELECT PC TYPE" window, use the [↑] and [↓] keys to select
the target programmable controller model and press the [GO] key.
The window shown on the right is displayed.
The window on the right is displayed when "F2/2K" is selected.
■ About the display of cursor for selecting models at startup
If the program is already stored in the RAM memory of FX-20P-E, the
cursor is displayed on the relevant model.
If a different model is selected, the window on the right is displayed.
Press the [GO] key to delete the program stored in the RAM memory
of FX-20P-E. A "SELECT MODE" message is displayed. To check the
content, press the [CLEAR] key.
For information on how to display programs, refer to the FX-20P-E-FKIT Operation Manual.
2.3.2
Reading the program to be converted from F
FX-20P-E-FKIT reads and creates programs offline. Thus, it is necessary to read the program from
the target programmable controller in the RAM memory of FX-20P-E using the following steps. This
section describes the operation to read programs from the target programmable controller (F
or F
).
2
(1) Press the [OTHER] key to display the "MODE MENU" window.
(2) On the "MODE MENU" window, use the [↑] and [↓] keys to select
"2.HPP↔PC" and press the [GO] key. The "2.HPP↔PC" window is
displayed.
, F
, or F
).
1J
2
1
F
, F
, and F
1
1J
2
programmable controllers
, F
, or F
1
1J
, F
, and F
1
1J
FX-20P-FIM
I M
P - F
- 2 0
F X
FX-20P-E
) to display the
2
SELECT PC TYPE
F2, F1
F2/2K
F2/2K
STEPS LEFT 1024
SELECT MODE
PC TYPE MISMATCH
HPP ALL CLEAR?
OK [GO]
NO [CLEAR]
programmable controllers
2
MODE MENU
1. PROGRAM CHECK
2. HPP
3. F FX CONVERT
4. BUZZER LEVEL
2. HPP
HPP PC
HPP PC
HPP : PC
1
2
3
A1
A2
A3
, F
,
1
1J
PC
PC
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Melsec-f

Table of Contents