Overview Of Program Conversion Using Fx-20P-E; Program Conversion Procedure; Items To Prepare - Mitsubishi Electric FX Series Replacement Manual

2. OVERVIEW OF PROGRAM CONVERSION USING FX-20P-E

2. OVERVIEW OF PROGRAM CONVERSION USING FX-
20P-E
2.1

Program Conversion Procedure

Preparing for program conversion
Converting programs
Writing programs into the FX3 series
Checking and modifying the program,
and performing an operation check
2.2

Items to Prepare

Prepare the following items to use FX-20P-E to convert programs of F
controllers to programs for FX3 series programmable controllers. For details on the connection
configuration with programmable controllers, refer to Chapter 1.5.1.
• The F , F
1 1J
• Paper describing the program to be converted
There are instructions that cannot be converted by the FX-20P-E-FKIT program conversion
function. The paper is needed to modify the program after executing the program conversion
function.
• The FX3 series programmable controller to store the converted program
• FX-20P-E (-SET0)
• FX-20P-E-FKIT
FX-20P-E-FKIT consists of FX-20P-FIM and FX-20P-MFA-E.
• Programming tools GX Works2 or FX-30P, which are compatible with the FX3 series, can be
used to check or modify the converted program.
• Programming tool and programmable controller manual
or F programmable controller containing the program to be converted
2
· Turn on FX-20P-E + FX-20P-E-FKIT.
(Refer to Chapter 2.3.1.)
· Read the program to be converted from F
and F programmable controllers.
2
(Refer to Chapter 2.3.2.)
· Convert the target program for the FX series.
(Refer to Chapter 2.3.3.)
For information on program conversion rules,
refer to Chapter 3.
· Write the converted program into the FX3 series.
(Refer to Chapter 2.3.4.)
· Check and modify the converted program, and
perform an operation check.
(Refer to Section 2.4.)
, F
1
, F ,
1 1J
, F programmable
1J 2
15
1
2
3
A1
A2
A3