AEG 72620 Instruction Book page 35

When the additional rinse function is selected, the RINSE
the program progress display illuminates prior to program start and
during the additional rinse.
4. If you wish to check whether the additional rinse function is selected:
– Turn the program selector to SHORT SPIN.
– Press the SOAKING button briefly.
+
If RINSE flashes on the program progress display, the additional rinse
function is set.
Disabling the Additional Rinse Function:
1. Turn the program selector to SHORT SPIN.
0
2. Press the SOAKING button for at least 5 seconds.
As soon as the button is pressed RINSE
progress display. After 5 seconds RINSE
nates continuously for a further 5 seconds.
3. Whilst RINSE
button.
Once RINSE
disabled.
Wash-Water Cooling
The water is cooled prior to pumping out at the end of the main wash
3
(by adding cold water). This setting is only effective for COTTON/LINEN
at a temperature of over 40° C.)
Wash-water cooling is not selected upon delivery from the factory.
Select Wash-Water Cooling:
0 1. Turn the program selector to SHORT SPIN.
2. Press the PRE WASH button for at least 5 seconds.
After the button has been kept pressed for 5 seconds, MAINWASH
flashes on the program progress display for 5 seconds.
3. Whilst MAINWASH is flashing, release the PRE WASH button.
After blinking has stopped, wash-water cooling is selected. It remains
functional until it is deleted.
4. If you want to check and see if wash-water cooling has been selected:
– Turn the program selector to SHORT SPIN.
– Press the PRE WASH button briefly.
If MAINWASH flashes on the program progress display, the wash-water
cooling function is set.
+
is continuously illuminated, release the SOAKING
+
has ceased to illuminate, the additional rinse function is
Operating Instructions
+
flashes on the program
+
ceases to flash and illumi-
+
indicator on
35