What To Do When; Trouble Shooting - AEG 72620 Instruction Book

Operating Instructions

What to do when...

The whistling noise when spinning may be different to
3
your prevous washing machine which is due to the
modern drive system.

Trouble Shooting

If you call out an engineer and the fault is listed here, a charge is levied
even if the appliance is in guarantee.
• If the error code (1, (2 or (d is displayed in the multi-display, check
the troubleshooting guide below before calling an engineer.
After eliminating the error, press the START/PAUSE button. If the
error code is displayed again, please contact your local AEG Service
Force Centre
• For all other errors displayed in the multi-display, please contact your
local AEG Service Force Centre, stating the error code.
Malfunction
Washing machine does
not work.
No water flows in.
Error code
appears.
Error code
28
Mains plug is not plugged in. Insert mains plug.
House fuse is defective.
Door is not closed properly.
START/PAUSE button not
pressed for long enough.
Tap is closed.
Filter in the threaded fitting
(1
on the water inlet hose is
blocked.
Door is probably not closed
(d
appears
properly.
Possible Cause Remedy
Replace fuse.
Close door; lock must engage
audibly.
Keep START/PAUSE button
pressed until the program
starts.
Open tap.
Unscrew the hose from the
tap, remove the filter and
clean under running water.
Close the door again. Press
the door firmly in the area of
the lock.