AEG 72620 Instruction Book page 29

Malfunction
Washing machine
vibrates during opera-
tion or is unstable.
Excessive foaming dur-
ing the main wash
Water runs out from
under the washing
machine.
Fabric softener is not
added, compartment
À for fabric softener
is filled with water.
Washing is creased.
Possible Cause
The machine is not level.
There is only very little wash-
ing in the machine (e.g. only
a bath robe).
Water could not be com-
pletely pumped out prior to
spinning because
the drain hose is kinked or
the drain pump is blocked.
Probably too much detergent
was used.
Threaded fitting on the
water inlet hose is leaking.
The inlet hose has a leak.
The drain pump cover is not
tight.
Washing is caught in the
door.
Suction cap in the fabric sof-
tener compartment is not
correctly fitted or is blocked.
Too much washing was
placed in the appliance.
Operating Instructions
Remedy
Adjust the feet according to
the installation and connec-
tion instruction.
Does not impair function.
Check the drain hose and if
necessary remove any kink or
clean the drain pump and
remove any foreign bodies
from the pump housing.
It may be necessary to
reduce the amount of deter-
gent used. Follow the deter-
gent manufacturer's
recommendations.
Tighten the inlet hose con-
nections.
Check the inlet hose and if
necessary replace it.
Tighten cover by turning
clockwise.
Stop the program, remove
the washing caught in the
door, start a new program.
Clean detergent dispenser
drawer, place suction cap
firmly in position.
Put less washing in the
appliance.
29