Using The Headphone Hook; Connecting A Microphone - Roland HPi-7S Owner's Manual

Roland digital piano owner's manual model hpi-7s
Hide thumbs Also See for HPi-7S:
Table of Contents

Advertisement

Some Notes on Using Headphones
• To avoid damaging or severing the headphone cord, be sure to
handle the headphones by holding the phones themselves, and
grasping the plug and not the cord when pulling the headphone
plug.
• To prevent possible auditory damage, loss of hearing, or
damage to the headphones, the headphones should not be used
at an excessively high volume. Listen at appropriate levels.
• The headphones may be damaged if the volume is too high when
they are plugged in. Connect the headphones only after turning
the volume down completely.
• Please use stereo headphones.

■ Using the Headphone Hook

Whenever you are not using the headphones, you can hang them on
the headphone hook at the lower left of the HPi-7S.
Attaching the Headphone Hook
1.
Press and twist the headphone hook included with the HPi-
7S into the hole in the bottom left of the HPi-7S (refer to the
figure below).
2.
Turn the headphone hook wing nut to secure the
headphone hook.
fig.HeadphoneHook
Hole
Wing
nut
Headphone
Hook
Some Notes on Using Headphone Hook
Do not hang anything other than headphones on the headphone
hook. Doing so may damage the instrument or the hook.

Connecting a Microphone

You can connect a microphone into the Mic jack, and enjoy karaoke
with the HPi-7S.
1.
Connect a microphone (sold separately) to the Mic jack
located in the jack panel on the lower left of the HPi-7S.
2.
Rotate the Mic Volume knob on the left side of the Mic jack
to adjust the volume level for the microphone.
3.
Adjust the mic echo (p. 90).
Some Notes on Using a Microphone
• Be careful of high volume levels when using mikes late at night or
early in the morning.
• When connecting a microphone to the HPi-7S, be sure to lower
the volume. If the volume control is too high when the microphone
is plugged in, noise may be produced by the speakers.
• Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
• Changing the orientation of the microphone.
• Relocating microphone at a greater distance from speakers.
• Lowering volume levels.
Before You Begin Playing
19

Advertisement

Table of Contents
loading

Table of Contents