Replacing And Adjusting The Presser Foot (1) - Janome MB-7e Service Manual And Parts List

Replacing and Adjusting the Presser Foot (1)

Needle cramp
cushion
Needle clamp
Needle clamp
screw
Setscrew
Setscrew
Presser foot
1. Remove the lower thread guide plate unit and thread
catcher panel. (see page 8)
2. Loosen the needle clamp screw and the setscrew.
Remove the needle, needle clamp and needle clamp
cushions (2 pcs.).
NOTE:
The presser foot will spring down when the needle
clamp is removed.
3. Remove the setscrew and replace the presser foot.
4. Attach the needle, needle clamp and needle clamp
cushions. Tighten the needle clamp screw and
setscrew.
5. Adjust the needle height. (see Adjusting the needle
height) (see page 32.)
6. Push the needle bar down to engage the needle bar
clutch.
20