Makita BTD141 Series Technical Information page 9

W
iring diagram
[2] Wiring in Housing
Fig. D-3
[2] -1. Lead Wires of LED
As illustrated below, fix the two Lead wires (black, white) of LED
with Lead wire holders, and route them between the pin and the boss.
Lead wire holder
pin
boss
Connector
Light circuit
[2] -2. Other Lead Wires
Brush holder complete
Assemble each Connecting
terminal to Switch at approx.
20 degrees to the vertical.
Lead wire holder
With these lead wire holders,
fix the lead wires connected
to each connector.
Connector (large)
Connector (small)
Put the following lead wires
between the rib and Light circuit.
*Lead wires (red and black) from
Terminal to Connector (small)
*Lead wire (blue) from Switch
to Connector (small)
Lead wire holder
Do not cross the lead wires of LED here.
rib
LED
Fit the corner of LED in this
corresponding corner of Housing (L).
Be sure that Lead wires
of LED are tight in this area.
20°
Switch
Terminal
P 9/9
LED
The lead wire (blue) from
Connector to Switch has to
be routed inside of this pin.
pin
Light circuit
Put Light circuit in place
so that the orange Lead wire
faces toward the Terminal side.
Switch side
Lead wire
(orange)
Terminal side