Page 1
INSTRUCTION MANUAL Cordless Impact Driver BTD130F BTD140 BTD141 BTD142 008432 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
The tool is intended for screw driving in wood, metal and We declare under our sole responsibility that this plastic. product is in compliance with the following standards of For Model BTD130F standardized documents; ENG102-1 For European countries only EN60745,...
Page 3
GEA006-1 personal injury. Use personal protective equipment. Always General Power Tool Safety wear eye protection. Protective equipment such Warnings as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions WARNING Read all safety warnings and all will reduce personal injuries.
22. Keep cutting tools sharp and clean. Properly Hold the tool firmly. maintained cutting tools with sharp cutting edges Wear ear protectors. are less likely to bind and are easier to control. SAVE THESE INSTRUCTIONS. 23. Use the power tool, accessories and tool bits etc.
power. Switch action Never recharge a fully charged battery 1. Switch trigger cartridge. Overcharging shortens the battery service life. Charge the battery cartridge with room temperature at 10 ゚ C - 40 ゚ C (50 ゚ F - 104 ゚ F). Let a hot battery cartridge cool down before charging it.
Page 6
Use only the driver bit or socket bit shown in the figure. Do not use any other driver bit or socket bit. 007521 For Models BTD130F,BTD140,BTD142 To install the bit, pull the sleeve in the direction of the The hook is convenient for temporarily hanging the tool.
OPERATION Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. NOTE: Use the proper bit for the head of the screw/bolt •...
Page 8
Raise the arm part of the spring and then place it in the If you need any assistance for more details regarding recessed part of the housing with a slotted bit these accessories, ask your local Makita Service Center. screwdriver of slender shaft or the like. Screw bits •...
Page 12
Makita Corporation Anjo, Aichi, Japan 884617D221...