Table of Contents
Advertisement
12. Mount the WASPs over and around the strength area to ensure full coverage of data connectivity.
a. Using an appropriate tool (i.e. cell-phone SIM release tool, paperclip), gently press the 'Config Enable' button
located on the downward (weight stack facing) face of the Guide Rod Retainer/SMARTconnect Sensor Housing.
You should get a slight confirming feel when the button is pressed properly.
b. The LCD should display three numbers arranged vertically in the upper are of the LCD, and three letters, or
numbers, in the bottom region of the LCD. They should disappear after several seconds.
c. The system is now in 'Normal Mode'.
13. When the system has been placed back in 'Normal Mode', user will be automatically redirected to the next screen.
14. Confirm calibration was successfully recorded and move to the next machine.
15. If calibration data was not successfully recorded, re-try full calibration procedure for this machine.
Post-Installation Checklist
Installation complete criteria.
• All units visible and connected within LF Assist
• All units either verified or calibrated with field calibration tool
• All units displaying no service indicators on the LCD display (battery level, WIFI connectivity, service required)
If any of these items are not complete, proceed with standard Service troubleshooting process.
Page 12 of 55
Advertisement
Table of Contents
