Installation - Dometic C Series Installation And Operating Manual

C35F, C55F, C75F
6

Installation

6.1 Selecting the installation location
Observe the following, when selecting the installation location:
• The ground must be level and sufficiently stable to support the wine cooler at full
capacity.
• The wine cooler must be positioned so that the plug is accessible.
• Note the information on the electrical connection, see chapter "Connecting the
wine cooler" on page 17.
➤ Remove all the inner and outer packaging material before setting up.
6.2 Integrating free-standing wine coolers
The wine cooler can be integrated either under a counter top or between other cab-
inets.
Observe the following, when integrating the wine cooler:
• Observe the installation dimensions (fig. 3, page 4).
• Ensure the door will open and close properly in the chosen location.
• Waste heat produced by the wine cooler must be extracted via ventilation open-
ings on the rear and at both sides.
6.3 Adjusting the feet
➤ Ensure the wine cooler is level by adjusting the feet (fig. 4, page 5).
6.4 Connecting the wine cooler
Observe the following when connecting the wine cooler:
• Leave the wine cooler to stand upright for about 2 hours after transporting,
before you connect it to the power supply. Otherwise this could cause faults in
the cooling system.
• Connect the wine cooler to a circuit that is protected with 15 A.
• Have the socket and power circuit checked by a qualified electrician to ensure
that the socket is earthed correctly. Do not use an extension cable or a multiple
power socket.
• The power cable must be securely behind the wine cooler and not lying or hang-
ing unprotected.
EN
Installation
17