Set Command - Planet WGSW-2840 User Manual

3.5.2.5 Set command

Set command is to change the parameter of the switch functions. The follow table lists the set commands
and the equivalent usages.
Command
set channel
set default
set enable password
set igmp-snooping disable
set igmp-snooping enable
set ip http server disable
set ip http server enable
set ip telnet server disable
set ip telnet server enable
set mirror
set mirror capture-port
set mirror monitored-port egress
set mirror monitored-port ingress
set multicast router
set password
set port disable
set port duplex
set port enable
set port flow-control
set port rate-shaping egress
set port rate-shaping ingress
set port rate-shaping egress
set port rate-shaping ingress
set port spantree <port_num> portco
set port spantree <port_num> portfa
set port spantree <port_num> portpr
set port speed
set port storm-limit mode
set port storm-limit rate
set qos map cos-queue-map
set qos map dot1p-cos-map
set qos map mac-cos-map
set qos map port-cos-map
Description
Set ports to be channel
Set system load default parameters
Set the password for the privileged level of the CLI
Disable igmp snooping
Enable igmp snooping
Disable http server
Enable http server
Disable telnet server
Enable telnet server
Enable/Disable mirror function
Set a port to capture traffic
Capture egress traffic
Capture ingress traffic
Set multicst router port
Set the password for telnet
Disable a port
Set port transmission type
Enable a port
Set port traffic flowcontrol
Set port egress rate-shaping rate
Set port ingress rate-shaping rate
Set port egress rate-shaping rate
Set port ingress rate-shaping rate
Set spanning tree port cost
Set spanning tree PortFast feature
Set spanning tree port priority
Set port transmission speed
Set port storm limit mode
Set port storm limit rate
Set the queue number of each cos
Set the cos value of each dot1p priority
Set MAC based qos
Set port's cos