Resetting A Button To Its Original Function; Service And Support; Frequently Asked Questions - Philips SRP2003/27 User Manual

8
............ digit buttons for direct
channel / track selection.
9
................................ switches the selected
device on / off.
Note
For some TV brands / types, this button will
only turn off the TV. You will have to press a
digit button (direct channel selection) to turn
on the TV again.
3.2 R esetting a button to its
original function
If an improved button (see chapter 2.2.2) still
does not function as expected, you can always
reset the button to its original function.
1
In the current
device mode, keep
digit buttons
pressed
and
simultaneously for 5
seconds, until the
red Setup light lights up.
• The remote control is now in setup
mode.
2
Press digit buttons
, , and , in
that order.
• After each
button press
the red Setup
light blinks once.
3
Press the button
that you wish to
reset twice. E.g. the
22 button.
• After each
button press
the red Setup light
• The red Setup light
more time to confirm that the button
was succesfully reset to its original
function.
10 EN
5 sec.
2 x
blinks once.
will blink one
4 Service and support
4.1 Frequently asked questions
In this chapter you will find answers to the most
frequently asked questions about your universal
remote control.
4.1.1 Setup
I cannot enter setup mode.
Battery level too low or battery lifetime came
to an end.
• Replace the batteries. See chapter 2.1.
After replacing the batteries, test if the
remote control still operates your devices. If
it does not, you have to set up the remote
control again. For this refer to chapter 2.2.
The brand code for my device is missing in the
'Shortlist of brands' in the Quick Start Guide.
The 'Shortlist of brands' only mentions the most
common TV, DVD and CBL/SAT brands.
• You will find a complete brand list on page
16-28 of this user manual.
•
Use '9999' as 4-digit code in case you cannot
find your brand in the complete brand list.
Note that using '9999' may result in a long
setup (up to 15 minutes).
My TV switches OFF in step 4 but does not
switch ON again in step 5.
TVs of some brands (e.g. Panasonic) only
switch ON after a long press on one of the
digit buttons. After a long button press in setup
mode the remote control will start trying to
improve the button (see chapter 2.2.2) instead
of switching ON the TV.
• In this case, switch ON the TV manually
or use the original remote control for this.
Continue with step 6. After successfully
completing setup, the remote control will
switch ON the TV with a long button press
on one of the digit buttons, just as your
original remote control.
EN 11