After setup, not all buttons work al expected.
•
Try improving the button(s). See chapter
2.2.2.
How do I set the remote control for my TV /
DVD combo?
Some combo devices require you to set up two
different source selection buttons to control
both parts of the combo device. If you have a
TV / DVD combo, you might need to set up
the remote control for both TV and DVD to
operate your TV / DVD combo.
4.1.2 Operation
The remote control does not wake up
anymore.
Battery level too low or battery lifetime came
to an end.
Replace the batteries. See chapter 2.1.
•
After replacing the batteries, test if the
remote control still operates your devices. If
it does not, you have to set up the remote
control again. For this refer to chapter 2.2.
The device I want to operate does not respond
at all / does not respond to all of the button
commands.
•
Check if the buttons you press are available
on the original remote control of the device.
Try improving buttons. See chapter 2.2.2.
•
Wrong code selected during setup.
•
Set up the remote control again for the
device. Always test if the device responds,
before leaving setup mode.
It may be that the buttons that you are trying
to use have a different naming on the original
remote control.
•
Try out all buttons to find the one(s) you
need.
EN