Resetting A Button To Its Original Function - Philips SRP1103 User Manual

4
+ VOL - ...................... adjusts TV volume.
................................ previous program / Last /
Back.
................................. mutes TV sound.
+ CH - ....................... next / previous channel.
5
5 .................................. rewind.
2 .................................... play.
6 .................................. fast forward.
9 .................................... stop.
0 ................................... record.
; ..................................... pause.
4P 3P ........................ previous (4P) / next
(3P) page / track in
various modes.
/ ....................... set your Thumb ratings.
6 ............ digit buttons for direct
channel / track selection.
................................ used after direct channel
selection. Some devices
require
pressed after channel
selection.
.......................... selects between one
and two-figure channel
numbers.
10 EN
to be
3.2 Resetting a button to its
original function
If an improved button (see chapter 2.2.2) still
does not function as expected, you can always
reset the button to its original function.
1
In the current
device mode, keep
digit buttons
and pressed
simultaneously for 5
seconds, until the
red Setup light lights up.
• The remote control is now in setup
mode.
2
Press digit buttons
, and , in
that order.
• After each
button press
the red Setup
light blinks once.
3
Press the button
that you wish to
reset twice. E.g. the
22 button.
• After each
button press
the red Setup light
• The red Setup light
more time to confirm that the button
was succesfully reset to its original
function.
5 sec.
2 x
blinks once.
will blink one
EN 11