LBA Mode Control
Sets addressing to use consecutive sector numbers (LBA = Logical Block Addressing).
If the hard disk supports LBA mode and it has a capacity of more than 528 MByte,
Enabled
then the BIOS uses converted hard disk parameters. This allows the disk's full
capacity to be used.
The BIOS uses the hard disk parameters and supports a maximum capacity of
Disabled
528 MBytes.
32 Bit I/O - Bus width for data transfer
This field specifies the bus width for data transfer between the processor and the hard disk controller.
The data transfer is 32 bits in width at the PCI bus. This enhances performance.
Enabled
The data transfer is 16 bits in width.
Disabled
Transfer mode
Specifies the method used to transfer data from the hard disk to the main memory.
Standard
Fast PIO_1
Fast PIO_2
Fast PIO_3
Fast PIO_4
FPIO 3 / DMA 1
FPIO 4 / DMA 2
Ultra DMA Mode – Transfer Speed
Performance,increasing
Harddisk
Specifies that the hard disk drive should use a fast Ultra DMA transfer mode.
The fast Ultra DMA transfer mode is not set.
Disabled
The fast Ultra DMA transfer mode is set.
Mode0, 1, 2,
3, 4, 5,6
SMART Monitoring
Shows whether SMART (Self Monitoring Analysis Reporting Technology)
monitoring is activated for the hard disk.
SMART monitoring is activated.
Enabled
SMART monitoring is deactivated.
Disabled
Fujitsu Technology Solutions
Main Menu – System functions
15