Power On Source: Wake Up Timer - Switch On According To Time; Power Failure Recovery - System Status After A Power Failure - Fujitsu D2912 Bios Manual

Power On Source: Wake Up Timer – Switch
on according to time
Switch onsystem
Specifies whether the system can be set to switch on at a particular time or after a
particular period of time. The switch-on date cannot be specified in BIOS Setup. A suitable
application is required in order to set the switch-on date.
The system can be switched on using timer control.
Enabled
The system cannot be switched on using timer control.
Disabled
Rebooting after a critical system error is not affected by this setting.
Power On Source: Wake Up Time – Switch on according to time
Wake UpTime
Specifies the exact point in time at which the system is to be switched on. 00:00:00
Power On Source: Wake Up Mode
Wake UpMode
Specifies the switch-on period.
The system is switched on daily.
Daily
The system is switched on monthly.
Monthly
Power Failure Recovery – System status
after a power failure
Power failure,system reaction
Specifies the system behaviour after a restart caused by a power failure.
Always Off
Always On
Previous State
Disabled
All wake up sources are reconfigured during the short initialisation process.
The system can be 'woken up' via LAN etc. When Disabled is set, the system
can only be 'woken up' using the power-on button.
Fujitsu Technology Solutions
The system switches on briefly, performs a status check (initialisation), and
then switches off.
The system switches on.
The system switches on briefly, performs a status check, and then returns the
mode it was in before the power failure occurred (ON or OFF).
The system does not switch on.
Power Menu – Energy saving functions
59