Table of Contents
Advertisement
Invacare® LiNX
4.5 Lock Mode
The lock mode is not set at the factory for every system, but
can be enabled by your provider. If this parameter is set ON,
you can use the lock function to restrict who can use the
system, but also can help prevent unintentional use of the
controls for when the system is not required for any length
of time. You can only lock a system when it is powered up
and you are user-in-charge. You can use the lock function to
restrict who can use the system, but also can help prevent
unintentional use of the controls for when the system is not
required for any length of time. You can only lock a system
when it is powered up and you are user-in-charge. Besides,
if the mobility device or a powered seating function cannot
move further into one direction, there is 4.6.7 Lock-out
indication, page 20.
Locking the System
1.
Press and hold the button for four seconds.
When entering a locked state, the mode button flashes
quickly, three times. The system is locked.
Unlocking the System
The secondary remote module can lock a system, but
cannot unlock it since it has no touch display or horn
button. To unlock a system locked by a secondary
remote module, use a primary remote module.
For primary modules with touch displays:
18
1.
Press the button once to power up.
2. Within 10 sec after power up, tap and hold lock screen.
A white square begins to show on screen.
3. Release hold only after white square has closed
completely.
The system is unlocked.
To unlock the system, an unlock sequence must be
performed by the user within a specific time frame.
If the sequence is not performed correctly, within
the time frame, the system will remain locked and
the system will power down again.
4.
For primary modules with physical horn buttons (e.g.
REM2xx):
1.
Press the button.
2.
Press the button twice. The system is unlocked.
The horn button must be pressed twice within
10 seconds of pressing the power button.
1608055-C
Advertisement
Table of Contents
