Panasonic KX-HTS Series Manual page 64

3.8 Starting the PBX
3.8 Starting the PBX
WARNING
Make sure that the AC outlet is properly earthed, then securely connect the 3-pin AC plug including
the earthed pin.
CAUTION
• Use only the AC power cord included with the PBX.
• Before touching the product (PBX, cards, etc.), discharge static electricity by touching ground or
wearing an earthing strap. Failure to do so may cause the PBX to malfunction due to static electricity.
• Once you have started the PBX, if you unplug the PBX, do not initialise it again as described in
Initialisation Procedure". Otherwise, your programmed data will be cleared. To restart the PBX, refer
to "6.1.4 Restarting the
• The plug of power supply cordset is used as the main disconnect device. Ensure that the AC outlet is
located near the equipment and is easily accessible.
Connecting the AC Power Cord
Note
For safety reasons, do not stretch or pinch the AC power cord.
PBX".
"System