Setting Linkup With The Switcher; Switcher Network Settings - Panasonic AW-RP50N Operating Instructions Manual

Setting linkup with the switcher

This setting is used to link the unit with an optional switcher
(AW-HS50).
To link the unit with the switcher, the following settings must
be established in the unit.
IP address (switcher) setting
[SYSTEM] menu  [SW IP ADR]
Assign information setting
[SYSTEM] menu  [SW CTL]
Link connection setting
[SETUP] menu  [SW LINK]  [SWLINK]
Settings at the switcher
For details on the settings selected at the switcher,
refer to the Operating Instructions of the switcher.
 Switcher network settings 
1
Set the MENU button to ON.
Press the MENU button to light its indicator.
2
Set PRESET MEMORY/MENU 10 button
(SYSTEM) to ON.
When the button is pressed and its indicator is lighted,
the [SYSTEM] menu is displayed on the LCD panel.
[ 1 ] C A M E R A C TL
3
Turn the F1 dial, display the SW IP ADR menu,
and press the F1 dial.
[ 9 ] S W I P AD R
1 . I P : S W
1 9 2 1 6 8 . 0 00 . 0 0 8
▼
Press the F1 dial.
4
Turn the F2 dial, select the IP address, and then
press the F2 dial to enter the selection.
Set the IP address which has been set in the switcher.
1. I P : S W
19 2 1 6 8 . 0 0 0 . 0 2 0
1. I P : S W
17 2 . 1 6 8 0 0 0 . 0 2 0
Input the IP address in four blocks of numerals.
When input advances to the last block and the F2 dial is
pressed, the IP address is entered.
1. I P : S W
17 2 . 1 6 8 . 0 0 0 . 0 3 0
5
Press the EXIT button.
Operation now returns to the SW IP ADR menu.
[9 ] S W I P A D R
6
Turn the F1 dial to display the SW CTL menu,
and press the F1 dial.
[ 3] S W C T L
1 .S W
7
Turn the F2 dial to select "Network", and then
press the F2 dial to enter the selection.
1. S W
27
Turn the F2 dial, and then press
it.
Press the F1 dial.
N o A s i g n
N e t w o r k