Setting The Functions When The Unit Is Linked With The Switcher; Setting The Image Output And Image Input - Panasonic AW-RP50N Operating Instructions Manual

Setting the functions when the unit is linked with the switcher

Set the various functions to be used when the unit is linked
with the switcher.
 Setting the image output and 
image input
This setting establishes the correlation between the image
output (remote camera) and image input (switcher).
By establishing the setting, the switcher is notified if a
remote camera which has been set is selected when the
remote cameras have been selected by the unit.
1
Set the MENU button to ON.
Press the MENU button to light its indicator.
2
Set PRESET MEMORY/MENU 10 button (SYSTEM)
to ON.
When the button is pressed and its indicator is lighted,
the [SYSTEM] menu is displayed on the LCD panel.
[ 1 ] C A M E R A C TL
3
Turn the F1 dial, display the SW ASSIGN menu,
and press the F1 dial.
[ 4 ] S W A S S IG N
1 . I N P U T 1
4
Turn the F1 dial to select the input line of the
switcher.
1 . I N P U T 1
2 . I N P U T 2
▼
Press the F1 dial.
▼
C A M 1
▼
CA M 1
Turn the F1 dial.
CA M 1
5
Turn the F2 dial, select the remote camera, and
then press the F2 dial to enter the selection.
2. I N P U T 2
2. I N P U T 2
The switcher has five input lines: INPUT1 to INPUT5.
Take the above steps to set the remote cameras for the input
lines, and then operate the remote cameras.
  Select "NoAsign" if the switcher is not to be notified of the
correlation setting when the remote cameras have been
selected.
29
C A M 1
Turn the F2 dial, and then press
it.
C A M 2