Table of Contents
Advertisement
DISK MENU
8 Disk Menu
The menu appears if the hard disk error is found during
power-up.
The buzzer beeps every 5 seconds, and ERROR indi-
cator turns off.
Press buttons other than [STOP] to mute buzzer beep.
Hard disk status and required operation are shown in the table.
Abbreviation Status
Capacity
Normal status
ERR
Writing error
LOST or * status was left for
five minutes.
*
Awaiting format
HDD error
HDD logically removed
LOST
HDD physically removed
ADD
HDD added, and awaiting
format
–
Previous time and this time,
HDD logically removed
You can implement necessary operation from among them.
REMOVE LINK: Removes logically the HDD link.
HDD FORMAT: Formats the HDD.
RESTART: Closes the menu, and returns to normal operation.
The menu can also be displayed manually when you need to format HDD, or to remove the logical link.
1. Turn off the power of the recorder once, and turn it on again.
The multi-screen monitor displays a message "SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY".
2. Press the [STOP] button.
The DISK MENU opens.
3. Select any of REMOVE LINK, HDD FORMAT, or RESTART.
Auto-remove
When no button is pressed for 5 minutes after opening the DISK MENU, The recorder will logically remove the disk that meets
any conditions below.
• An HDD has been categorized in " * ", "LOST", or "ERR".
• Restart was repeated 3 times due to writing error.
88
NO.1:117.95GB
NO.2:117.95GB
REMOVE LINK
HDD FORMAT
RESTART
Required
–
Format, remove link ,or replace HDD
if erred even after formatting.
Same as above.
Format
Replace HDD if erred even after
formatting.
Remove HDD to add a new one,
or reconnect.
Remove link, or add a new HDD.
Format
DISK MENU
SET
SET
SET
Note
Abbreviation SYS appears in SYSTEM
LOG when indicating a writing error.
Replaced HDD has been not format-
ted yet.
Replaced HDD malfunctions.
Appears only when manually opening
DISK MENU.
REMOVE LINK command has been
previously carried out .
Hard Disk Status
Operation
Advertisement
Table of Contents
