Valve Access And Service - Hearth and Home Technologies outdoor lifestyles Dakota 42-CE Installer's Manual

A. Valve Access and Service
• The gas valve can be accessed behind the cement
refractory panel on the right side of the fireplace.
• Lift doors out and set aside. There is a washer under each
door. Be careful not to lose the washers.
Figure 11.1 Lift Out Doors
• Remove logs if access is necessary after installation is
complete. See Section 9.C. Remove logs in reverse order
of set up.
• Remove grate if access is necessary after installation is
complete. (Refer to Section 9.B.)
• Remove two screws on side of pilot shield and remove
shield.
Figure 11.2 Remove Pilot Shield
• Use a phillips screwdriver to remove the two screws
securing the refractory retaining strip. Remove the
refractory side panel and set aside.
Figure 11.3 Loosen Refractory Retaining Strip
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Dakota 42-CE • 4036-915 Rev L • 10/09
WASHER
• Remove the inside valve access panel by lifting it up and
out.
Figure 11.4 Remove Valve Access Panel
• Use a phillips screwdriver to remove the exterior valve
access panel (remove four screws).
Figure 11.5 Remove Exterior Valve Access Panel
• Loosen lower pressure tap screw before attaching
manometer. Start up the fireplace to verify the pressure
and adjust as necessary. Reverse these steps to
reassemble before log positioning.
Note: Pressure tap screws must be re-tightened.
Figure 11.6 Connect Manometer
21