Table of Contents
Advertisement
7
Electrical Information
A. Ignition System Wiring
•
This fireplace is equipped with an electronic ignition
system which operates on a 6 volt system.
• The batteries are located within the ignition module which
is located within the external control box. A wiring diagram
is shown in Figure 7.1.
• The battery pack requires four AA batteries (not included).
See Section 11.B for battery replacement.
CAUTION
Battery polarity must be correct or module damage will
occur.
B. Remote Control
•
This fireplace is equipped with a remote control to
operate the ignition system.
• 9 volt battery required.
• Follow operating instructions included with remote
control.
PILOT
Figure 7.1
Electronic Ignition Wiring Diagram
10
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Dakota 42-CE • 4036-915 Rev L • 10/09
IGNITION MODULE
6VDC
BATTERY PORT
(4 AA BATTERIES)
ON/OFF
SWITCH
WARNING
Shock Risk
• Replace damaged wire with type 105° C rated wire.
• Wire must have high temperature insulation.
CAUTION
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
FLAME SPARKER/
SENSOR
PILOT GAS LINE
CONNECTED TO
BACK OF VALVE
VALVE
REMOTE
CONTROL
ANT.
ON/OFF
WALL SWITCH
IGNITION
MODULE
(6V)
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
VALVE
Advertisement
Table of Contents
