Operating From A Remote Location; Remote Operation Card - Panasonic KX-FPC95 Operating Instructions Manual

Operating from a remote
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (feature #11 on page 83) and set the unit to the TAD/FAX
mode before going out (p. 68).
Dial key Remote command
Skips the greeting message
0
1 Repeats a message
2
Skips a message
4
New message playback
5
All messages playback
6
Room monitor
7
Re-records a greeting message
Stops re-recording of a greeting
9
message

Remote operation card

Please cut out and carry this card for assistance when using the remote operation.
1. Call your unit.
2. Enter the remote operation ID
message.
3. Press the remote command
key(s) within 10 seconds (see
the reverse side).
Answering Device
Remote Operation
during the greeting
The new messages will be
played automatically.
If there are no new
messages, wait for 4
seconds. All the messages
will be played back.
Remote Operation
location!
Page Dial key
79
Erases a specific message
4
78
Erases all messages
5
78
Changes to the TEL mode
8 0
78
Turns ON message transfer
8 1
78
Turns OFF message transfer
8 2
79
Turns ON pager call
8 3
79
Turns OFF pager call
8 4
79
Notice of Remote Operation
The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
When the unit is in the TEL
mode, call your unit and wait
for 15 rings. The answering
device will temporarily answer
the line. Enter the remote
operation ID during the
greeting message. The unit will
switch to the TAD/FAX mode.
When you press a key, press
firmly.
To send a document, press
. When a fax tone is
9
heard, start transmission.
Remote command Page
79
79
79
79
79
79
79
77