Detection Mode - Panasonic WJ-HD316 Operating Instructions Manual

⁄4 Press the STOP button to stop
playback.
The indicator on the PLAY/PAUSE button will go off and
playback will be stopped.
Live image will be displayed on the monitor 2 and the VGA
monitor.

Detection Mode

Set how to detect motion in the set motion detection area.
There are 3 detection modes as follows:
Important
It is impossible to set two or more detection modes simulta-
neously.
<ANY AREA mode>
It will be subject to be listed if "motion" is detected in any of
the set motion detection areas.
A
C
Any motion will be detected anywhere in the A, B, C, D
areas.
Note: In the ANY AREA mode, it is possible set the mask-
ing duration. When the masking duration is set, motion
will be ignored for a certain period (set duration as the
masking duration) in the same area. It will be conve-
nient to set the masking duration to make the subject
period shorter in case that it is required to search from
the long time range or searching results are too many.
<VECTOR mode>
It will be subject to be listed if an object moves within the
set time to the other detection areas in the set order.
The following is an example.
10 S
A
C
10 S
Motion is detected in area B within 10 seconds after being
detected in area A.
Motion is detected in area C within 20 seconds after being
detected in area B.
B
D
B
D
Motion is detected in area D within 10 seconds after being
detected in area C.
When all of the above have occurred, an event action will
be performed.
<DURATION mode>
It will be subject to be listed if an object keeps on moving
for the set period in the detection area. For example, in
case of the following settings; 10 sec. for areas A and B, 20
sec. for area C and 30 sec. for area D:
An event action will be performed when an object keeps on
moving more than the set period in the specified detection
area.
A
C
B
D
35