Panasonic DMR E50 Operating Instructions Manual page 75

Play
Play fails to start even when [1]
(21) is pressed.
Play starts but then stops
immediately.
"NO READ", "UN SUPPORT",
"NO DISC" or "NO PLAY" appears
on the unit's display.
No response when buttons
pressed.
A title or chapter doesn't play
when it is selected.
Picture distorted during search.
Alternative soundtrack and
subtitles cannot be selected.
Soundtrack/subtitle language not
the one selected with the SETUP
menus.
No subtitles.
Angle cannot be changed.
You have forgotten your ratings
password.
Remote control
The remote control doesn't work.
Cannot operate the television.
≥Insert the disc correctly with the label facing up. (page 20)
≥This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, CD and MP3
disc. (page 10)
≥The disc is dirty. Clean it. (page 69)
≥The disc may be badly scratched. (page 69)
≥You inserted a blank DVD-RAM or DVD-R.
≥If "
" appears on the television,
the operation is prohibited by the unit or disc.
≥If the unit is not operating at all, press [
, TIMER] (12) again to turn the unit on. The unit may not be operating correctly due to
[
lightning, static electricity, or some other external factor.
≥The Child Lock function is activated. (page 54)
≥Some titles and chapters on DVD-Video are not played when you have changed the ratings
level. (page 62)
≥Some distortion is normal.
≥The languages are not recorded on the disc.
≥You may have to use the disc's menus to select languages.
≥The language is not recorded on the disc. (page 59)
≥Subtitles are not recorded on the disc.
≥Turn the subtitles on. (page 51)
≥This function depends on software availability. Angles can only be changed during scenes where
different angles are recorded ("
≥Return the unit's settings to the initial state (factory setting).
With the tray open, keep pressing [:/6] and [5/9] (45) on the main unit
simultaneously for 5 or more seconds.
≥The unit is on standby to make a timer recording ("
≥[DVD, TV] (15) is not switched to "DVD".
Switch to "DVD" when operating this unit. (page 8)
≥The remote control code is wrong.
Change to the correct code. (page 63)
≥The batteries are depleted. Replace them with new ones. (page 8)
≥Point the remote control at the remote control sensor on the main unit. (page 8)
≥Remove obstacles from between the remote control and main unit.
≥The Child Lock function is activated. (page 54)
≥The remote control code is wrong.
Change to the correct code. Some televisions cannot be operated even if you change the code.
(page 9)
≥[DVD, TV] (15) is not switched to "TV".
Switch to "TV" when operating the television. (page 9)
75
Troubleshooting guide (continued)
, TIMER] (12) to switch the unit to standby, then press
" appears on the display).
" on the unit's display is on). (page 32)