Remote Setting; Operating Other Panasonic Dvd Equipment With The Remote Control - Panasonic DMR E50 Operating Instructions Manual

Remote Setting

Preparation
≥Switch [DVD, TV] (15) to "DVD".
≥Press [FUNCTIONS] (11) to show the FUNCTIONS window.
Use [3, 4, 2, 1] (10) to select "SETUP" and press
1
[ENTER] (10).
≥The SETUP screen appears.
DVD-RAM
Disc Protection Off
FUNCTIONS
Cartridge Protection Off
DISC INFORMATION DIRECT NAVIGATOR CREATE PLAY LIST
SELECT
TIMER RECORDING
ENTER
RETURN
TOP PLAY
SETUP
Use [3, 4] (10) to select the "Settings" tab and
2
press [2] or [1] (10).
SETUP
Remote DVD 1
Clock
Owner ID
Tuning
Settings
Shipping Condition
Disc
Picture
Sound
Display
Tab SELECT
Connection
RETURN
Use [3, 4] (10) to select "Remote" and press
3
[ENTER] (10).
Use [3, 4] (10) to select "DVD 1", "DVD 2" or
4
"DVD 3" and press [ENTER] (10).
≥DVD 1:
Select this setting on both the unit and the remote control for
normal use with one unit.
≥DVD 2/DVD 3:
Select this setting on both the unit and the remote control
when using this unit and another Panasonic unit in the same
place. This ensures that you can operate both units
independently with their respective remote control.
It also allows you to operate both units with a single remote
control, simply by changing the remote control mode on the
remote control.
5
To change the remote control mode on the remote
control itself, press [ENTER] (10) and the numeric
buttons (4) corresponding to the code you want to
set, [1], [2], or [3], at the same time.
Press [RETURN] (23).
6
PLAY PLAY LIST
FLEXIBLE REC
Changing the unit's settings (continued)
Operating other Panasonic DVD
equipment with the remote control
By changing the remote control code, you can operate other DVD
Recorders and players manufactured by Panasonic.
Most of the DVD Recorders and players manufactured by
Panasonic use the same system for their remote controls, so if you
operate them in the same place, the controls can be confused by
the different pieces of equipment. Use the following procedure to
change the remote control code to solve this problem.
≥Use "1", the factory set code, under normal circumstances.
Preparation
≥Switch [DVD, TV] (15) to "DVD".
Press [ENTER] (10) and the numeric buttons (4)
corresponding to the code you want to set, [1], [2], or
[3], at the same time.
Note
≥Be sure to set the same remote control code on the main unit as
you did for the remote control itself (page 59, "Settings" —
"Remote").
≥The following display appears on the unit's display if its code and
the remote control's code are different. Change the remote
control's code to suit the unit.
The unit's remote control code
≥The display disappears after about 5 seconds.
63