Vcr Mode; Playing Back; Finding A Scene You Want To Play Back - Panasonic Palmcorder MultiCam PV-VM202 Operating Instructions Manual

1
CAMERA
VCR
CARD P. B.
3
A B
C D
!
28

Playing Back

3
The recorded scene can be played back immediately after recording.
BACKLIGHT
1
Slide the [OFF/ON/MODE] Switch and set the Palmcorder in
CAMERA
STILL the VCR Mode.
2
≥The [VCR] Lamp lights up.
2
Press the [6] Button to rewind the tape.
≥Rewind the tape to the point where you want to start playback.
2
≥When the tape reaches the beginning, rewinding stops automatically.
3
Press the [1] Button to start playback.
To Stop Playback
Press the [
≥If a Cassette recorded with copyright protection signals is played back, the
screen becomes blue or mosaic-like noise patterns appear.
ª Adjusting the Sound Volume
W.B./SHUTTER/IRIS/
4
MF/VOL/JOG
2 1
Until the [VOLUME] Indication
PUSH
4
. Then, rotate the [PUSH] Dial to adjust the volume. After the adjustment,
press the [PUSH] Dial to make the [VOLUME] Indication disappear.
OFF ON MODE
1
To adjust the volume with the Remote Controller, press the [T] or [W] Button
POWER
to display the [VOLUME] Indication. Press the [T] Button to increase the
volume or press the [W] Button to decrease the volume. The [VOLUME]
Indication goes off 2 or 3 seconds after the adjustment is finished.
≥When the Playback Zoom Function is in use, the sound volume cannot be
adjusted.
≥For other notes, see page 62.
~~~~~~~~~~~~~~~~~~~~~~~~

Finding a Scene You Want to Play Back

ª Cue/Review Playback
Cue Playback
Press the [5] Button
Review Playback
Press the [6] Button
W.B./SHUTTER/IRIS/
2
MF/VOL/JOG
≥If the Button is held continuously, it turns to Cue Playback or Review
2 1
PUSH
Playback until you release it.
≥If the Button is pressed briefly, Cue Playback or Review Playback continues
1
BACKLIGHT
even when it is released.
ª Hyper Check Function
CAMERA
STILL
If you press the [5] Button during fast-forwarding of the tape or the [6]
Button during rewinding of the tape, Cue Playback or Review Playback
1
continues for as long as the Button is held down.
ª Variable Speed Search Function
2
The speed of Cue Playback or Review Playback can be varied.
1
During playback, press the [1] Button.
≥[1k!] Indication appears.
2
Rotate the [PUSH] Dial and select a desired search speed.
The following 6 playback speeds are available for the Variable Speed Search
Function in both the fast-forwarding and rewinding directions. 1/5k (slow
playback, SP mode only), 1/3k (slow playback, LP mode only),1k, 2k, 5k,
10k, and 20k.
≥The same setting can be performed using the Remote Controller's the
[VAR.SEARCH] Button, the [π] Button and the [∫] Button.
Resuming Normal Playback
Push the [
R!
≥During Cue or Review Playback, fast-moving images may show mosaic-like
noise patterns. This is not a malfunction.
≥The sound is muted during search.
ª Repeat Playback
If you hold down the [1] Button for 5 seconds or longer, the Palmcorder
switches to Repeat Playback Mode, and the [R !] Indication appears
(To cancel Repeat Playback Mode, set the [OFF/ON/MODE] Switch to
[OFF].)

VCR Mode

1
∫
2
] Button .
3
appears, keep pressing the [PUSH] Dial
A
1
during playback.
B
2
during playback.
C
1
] Button.
D
.