Tad/Fax Mode (Receiving Phone Calls And Faxes Automatically) - Panasonic KX-FPG176 Operating Instructions Manual

Setup
TAD/FAX mode!
(receiving phone calls and faxes automatically)
When TAD/FAX mode is set, the unit will work as a fax machine and/or answering device.
If a fax tone is detected, the unit will automatically receive the fax. If a phone call is detected, the
answering device will play a greeting message and the caller can leave a voice message.
Setting up the voice and fax message reception
1 Make sure that feature #77 is set to
"TAD/FAX" (p. 75).
2 If the arrow ( ) is not shown on the right of
the display, turn it on by pressing
PQ.
The unit will play the pre-recorded greeting
message.
The display will show the ring setting in
TAD/FAX mode.
Display:
3 If you wish to change the ring setting, press
+ or - until the desired setting (see
below) is displayed, and press w.
You can adjust the speaker volume after
changing the ring setting. Press + or
- while listening to the greeting
message.
The remaining time for recording incoming
messages will be displayed.
Example:
Note:
If the arrow ( ) is already shown on the right of the
display and you wish to change the ring count, turn it
off once then on again by pressing PQ
and follow the instructions in step 3.
The incoming message recording time can be
changed (feature #10 on page 69).
When the remaining time is low, erase unnecessary
messages (p. 57). For the voice memory capacity of
incoming messages, see page 96.
While an incoming call is being recorded, you can
monitor it through the speaker. If this feature is not
required, set feature #67 to off (p. 74).
54
_TIME_=_10m13s
If6j/F3 3TD:2fyP &RCV CALL
AFTER 2 RINGS[±]
AUTO ANSWER SET