Toe-Kick; Cleaning The Appliance; Cleaning Behind The Toe-Kick - Thermador T24UR925DS Use & Care Manual

Toe-Kick

The Toe-Kick itself can be removed for service or
cleaning (see "Cleaning behind the Toe-Kick" in the
next section).
1. Remove the stainless steel Toe-Kick by unscrewing
and removing the two front screws with a Philips
screwdriver.
Front screws
2. You can remove the Toe-Kick by simply pulling it
out.
3. To reattach the Toe-Kick, align the holes with the
support tab and screw the frontal screws in the same
position with a Philips screwdriver.
NOTE: Removal of the kickplate is not encouraged,
but if necessary, it is recommended to be done by an
authorized service personnel.
Page | 10

Cleaning the appliance

WARNING:
Never clean the appliance with a steam cleaner!
CAUTION:
• Do not use abrasive or acidic cleaning agents and
solvents.
• Do not use scouring or abrasive sponges. The metallic
surfaces could corrode.
• Never clean the aluminum partitions in the dishwasher.
The parts may be damaged.
Proceed as follows:
1. Before cleaning: switch the appliance off. For
instructions, see "On/Off" section on the "Touch
Control" page.
2. Remove food and/or frozen food items and store in a
cool location.
3. Clean the appliance with a soft cloth, lukewarm water
and a little pH neutral detergent.
CAUTION:
When rinsing, water must not enter the interior drawer
light recesses located on the upper side of both the top
and bottom drawers. Water must also not spill out from
the bottom of the cabinet.
4. Wipe the drawer seals with clear water only and then
wipe dry thoroughly.
5. After cleaning switch the appliance back on.

Cleaning behind the Toe-Kick

1. Before cleaning: switch the appliance off.
2. Remove the Toe-Kick. See "Toe-Kick" section on the
previous page.
3. Use a vacuum cleaner with an extended attachment to
clean the accessible areas when they are dusty or dirty.
4. Replace the Toe-Kick.
5. Switch the appliance on.