Orion HCCA HCCA25001 Owner's Manual page 22

High performance car audio amplifier
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Symptom
Probable Cause
Speaker not connected to amplifier properly.
Internal crossover not set properly for speakers Readjust crossovers. Refer to the Internal Crossover Configurations section of
Speakers are blown
RCA shield connection is intermittent or faulty
Poor bass response
Speakers wired with wrong polarity causing
cancellation at low frequencies.
Crossover set incorrectly
Impedance load at amplifier is too low.
Battery fuse blowing
Short in power wire or incorrect wiring.
Fuse used is smaller than recommended.
Actual current exceeds fuse rating.
Speaker is blown with shorted outputs
© 2009 Directed Electronics. All rights reserved.
Action To Take
Check speaker wires and repair or replace as needed. Refer to the Speaker Con-
nections section of this manual for detailed instructions
this manual for detailed instructions.
Check system with known working speakers and fix or replace as needed.
Replace/Repair RCA cable
Check speaker polarity and fix as needed.
Reset crossovers. Refer to the Internal Crossover Configuration section of this
manual for detailed instructions.
Check speaker impedance load if below 1Ω, rewire speakers to achieve higher
impedance .
Check power wires and ground connections and repair or replace as needed.
Replace with proper fuse size.
Check speaker impedance load if below 1Ω, rewire speakers to achieve higher
impedance .
Check system with known working speakers and fix or replace as needed.
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hcca50001

Table of Contents