Rider Assembly; Seat And Safety Switch Assembly; Install Ground Speed Control Levers - Briggs & Stratton Simplicity Champion Zero-Turn Rider Adjustment Instructions Manual

Simplicity / Massey Ferguson / Snapper ZTR
Rider
Assembly
Seat & Safety Switch Assembly
1. Mount the seat (A, Figure 3) to the seat plate (B)
using four 5/16-18 nylock flange nuts (C) and tighten
securely.
2. Connect the seat switch wire harness (D) to the seat
switch.

Install Ground Speed Control Levers

1. Mount the control levers (F, Figure 4) to the control
lever base (E) using four 5/16-18 x 1" bolts, lockwash-
ers, and washers.
NOTE: The ground speed control levers and seat
must be adjusted to fit the operator. See SEAT
ADJUSTMENTS and GROUND SPEED CONTROL
LEVER ADJUSTMENTS in the Adjustments section.
B
Figure 3. Seat Installation
A. Seat
B. Seat Plate
C. 5/16-18 Nylock Flange Nut (4)
D. Seat Switch Wire Harness
D
E
Figure 4. Install Control Levers
A. 5/16-18 x 1" Bolts
B. 5/16 Lockwashers
C. 5/16 Washers
D. Control Lever
E. Control Lever Base
4
C
D
C
A B C
A