Advertisement
How to fix the goal gate.
Moving
Solenoid
Solenoid Capture
Goal Gate
If the gate is clicking, it is because the solenoid is not
catching in the Solenoid Capture hole. During shipment
and instillation the solenoid can bend inward toward the
gate. This results in the solenoid not catching in the
capture hole. To remedy pull the solenoid and slightly
bend the bracket down, away from the gate until the
solenoid is completely in the capture area and stops the
goal gate from "clicking". The clicking noise is the sensor
switch not getting the information to "lock" by the
solenoid.
Instructions:
1) Remove gate from table
2) Bend bracket down
3) Ensure proper alignment between solenoid and
solenoid capture hole.
18
Advertisement
