Set The Exerciser; Setting The Exerciser; Loaded Exercise - Kohler 14RCA Installation Manual

4.2 Set the Exerciser

Set the exerciser to automatically run the generator set
on the desired day and time every week or every two
weeks. See the generator set Operation Manual for
detailed descriptions of the exercise operation.
4.2.1

Setting the Exerciser

When power is applied to the RDC2 controller (when the
battery or the utility power for the battery charger is
connected), you will be prompted to set the date and
time, and then to set the exerciser.
The first setting will flash. Press the Up and Down arrow
buttons to change the setting. Press Select to save the
setting and move on to the next. Repeat until the date,
time, and exercise are set and the controller display
shows the main menu. See the generator set Operation
Manual for more detailed instructions to set the date and
time and set the exerciser.
Press AUTO to place the generator set controller into
automatic mode.
36 Section 4 Prestart
Date:
05Dec2011
Time:
08:31am
Next Exercise:
08:31a 12Dec2011
Figure 4-1 Set Time, Date, and Exercise
4.2.2

Loaded Exercise

In order to set a loaded exercise using the RDC2
controller, a Kohler Model RXT transfer switch must be
connected. See the generator set operation manual for
instructions to set a loaded exercise.
To set a loaded exercise on a generator set connected to
a transfer switch other than a Model RXT, use the
transfer switch controller to set the exercise. Refer to
the transfer switch operation manual for instructions.
Setting will flash.
Press the up and down arrow
buttons to change the setting.
Press Select to save the
setting.
tp6803
TP-7091 2/21