1
2
1. Heating element
2. Heating probe
3. Thermostat
Figure 5-17 Oil Heater
Note: For Models 14RCA(L): If the generator set is
equipped with a carburetor heater, obtain kit
GM102228-S to replace the breather tube, air
cleaner spacer, and gaskets before installing the
breather tube and oil heaters.
If the generator set is equipped with a carburetor heater,
remove it before installing the breather tube and oil
heaters.
The breather tube heating element wraps around the
breather tube from the engine to the air cleaner.
Before installing the oil heater kit, drain the oil from the
engine. Insert the oil heater near the oil drain valve using
the coupling provided in the kit. The oil heater power
cord connects to the breather tube heater cord.
1
1. Engine
2. Pipe
3. Pipe coupling
4. Oil heater
Figure 5-18 Oil Heater, Typical
TP-7091 2/21
3
4. Label
5. 120 VAC male connector (connect to breather tube heater)
5.7.3
The alternator weather cover is used to prevent frost
and snow build up on the alternator brushes.
Follow the instructions provided with the kit to install the
alternator weather cover onto the alternator end
bracket. See Figure 5-19.
2
3
4
Figure 5-19 Alternator Weather Cover
4
5
Alternator Weather Cover
Section 5 Accessories
GM101483
IMG_1055
45