Writing Of Unit/Csco Data - Sony VPL-FH65 Service Manual

2-5-9. Writing of Unit/CSCO Data

1. Connect the power cord and set this unit to standby state.
2. Double-click QuickAccess3.exe to start the application.
3. Select a target model on the Model pull-down menu.
4. Select Write to Projector on the Read/Write pull-down menu.
5. Select the data type (Unit/CSCO) on the Data Type pull-down menu.
6. Click the [Next] button.
7. Click the [Browse...] button.
The file selection window is displayed.
8. Set the destination file for the obtained data.
9. Click the [Next] button.
10. Select the serial port used for connecting PC on the Serial Port pull-down menu.
Upper line: Serial port number used for connecting PC
Lower line: 38400 (not selectable)
11. Click the [Next] button.
The window displaying the file path, model name written in file, unit serial, serial number model
name of this unit, and serial number is displayed.
12. Click the [OK] button.
After completed, the massage "Turn Off and On the AC, and then Power On to enable the new set-
tings." is displayed.
13. Click the [OK] button.
Completed is displayed.
14. Disconnect the power cord from this unit.
15. Click the [Complete] button.
2-20 (E)
VPL-FH60