Pyrolytic (On Some Models Only) - Smeg SOPA6102TS User Manual

End of Vapor Clean
1. Press the touch button on the control
panel to exit the function.
2. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
3. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
4. In case of grease residues use specific oven
cleaning products.
5. Remove any remaining water from the oven
cavity.
6. Where fitted, reposition the self-cleaning
panels and the rack/tray support frames.
For greater hygiene and to avoid foods taking
on unpleasant odours:
• we recommend drying the inside of the oven
with a fan-assisted function at 160°C for
around 10 minutes.
• Where the self-cleaning panels are fitted,
we recommend drying the oven cavity with
a simultaneous catalytic cycle.
We recommend wearing rubber gloves
for these operations.
For easier manual cleaning of parts that
are difficult to reach, we recommend
removing the door.

Pyrolytic (on some models only)

See General safety instructions.
Pyrolytic cleaning is an automatic high-
temperature cleaning procedure which
causes dirt to dissolve. This process
makes it possible to clean the inside of
the oven very easily.
Preliminary operations
Before starting the pyrolytic cycle:
• Clean the internal glass pane following the
usual cleaning instructions.
• Remove any food residues or large spills
from previous cooking operations from the
inside of the oven.
• Completely remove all accessories from
inside the oven.
• For very stubborn encrustations spray an
oven cleaning product onto the glass (read
the warnings on the product); leave for 60
minutes, then rinse and dry the glass using
32 - CLEANING AND MAINTENANCE
kitchen roll or a microfibre cloth.
• If present, remove the temperature probe.
• Remove the rack/tray support frames.
• Close the door.
Pyrolytic function setting
1. After entering the special functions menu,
press the and
the control panel until the
selected.
1. Press the button to confirm.
The display shows the Pyrolytic function duration
(factory set to 2:30 hours).
2. Press the and
the control panel to set the duration of the
Pyrolytic function from a minimum of 2:30
hours to maximum of 3:30 hours.
Recommended pyrolytic cycle duration:
• Light dirt: 2:30
• Medium dirt: 3:00
• Heavy dirt: 3:30
3. Press the button to confirm.
It is not possible to start the pyrolytic
cycle if the temperature probe (if
available) is plugged in.
touch buttons on
function is
touch buttons on
91477A548/A