Symbols; Factory Adjustments; Special Checks And Protocols; Acceptance Test - Siemens MAMMOMAT Novation DR Installation Manual

Important Notes

Symbols

Factory Adjustments

The MAMMOMAT Novation
the adaptation to the on-site mains voltage, adjustment of the AEC and the functional
tests to be performed.
When the measurements to be made (kV, mAs, etc.) are within the tolerances stated in
these instructions, this confirms that the settings made in the factory have not changed
and the equipment is fully serviceable.
The equipment tested with 400 V, 2-phase in the factory.

Special checks and protocols

Acceptance Test

The acceptance test of the MAMMOMAT Novation
whenever a new MAMMOMAT Novation
changes that might affect performance have been made to an existing system.
The acceptance test of MAMMOMAT Novation
dures in this Quality Control Manual (SPB7-250.623.02...) ensuring that a basic mini-
mum image quality criteria is met before the system is used with patients.
All yearly tests from the Quality Control Manual have to be performed.
Depending on the country where the system is installed, additional tests have to be per-
formed.
•
RöV §16 regulations have to performed in Germany.
•
The DHHS regulations have to be performed in the USA.
Maintenance measurements must be made according to the DHHS Maintenance
Instructions (SPB7-250.662.01...) and the DHHS Supplements to the instructions
for use (SPB7-250.661.01...). Results must be recorded in DHHS Measurement
certificates (SPB7-250.663.01...).
Siemens AG
Medical Solutions
This symbol indicates exposure of X-ray radiation.
This symbol indicates that the measured values have to be entered in the
"Startup Protocol" on page 11 - 1.
DR
is adjusted, programmed and tested in the factory, leaving
SPB7-250.815.02
Rev. 02
DR
is recommended to be performed
DR
system has been installed and whenever
DR
involves performance of all QC proce-
Page 1 of 4
09.04 CS SD 24
2 - 1
2
2
2
2
2
DR
MAMMOMAT Novation
System