Napoleon PTHC38PK Manual,Instructions & Parts List page 13

STORAGE :
Between uses:
"
Turn the control knob to OFF position.
" O W "
Turn LP cylinder to OFF position.
Store heater upright in an area sheltered from direct contact with
inclement weather (such as rain, sleet, hail, snow, dust and debris).
If desired, cover heater to protect ecterior surfaces and to help prevent
build up in air passages.
During periods of extended inactivity or when transporting;
Turn the control knob to "OFF" position.
Disconnect LP Cylinder and move to a secure, well-ventilated area
out of the reach of children and stored outdoors.
Do NOT store in a location that will exceed 125 degrees F.
Store heater upright in an area sheltered from direct contact with
inclement weather (such as rain, sleet, hail, snow, dust and debris).
If desired, cover heater to protect ecterior surfaces and to help prevent
build up in air passages.
CLEANING :
1.Remove the reflector and emitter by removing the 4 pcs screws (
that fasten the emitter to the lower screen cone .
Any debris in the burner port should be cleared. Any rust can be
removed carefully with a wire brush. Never use a piece of wood,
or other materials that might break off and block the ports.
2.Remove lower cone cylinder by removing the 4 pcs screws (
which attach the lower cone cylinder to the control cylinder.
Clear debris on the surface of thermocouple.
3.Remove the 4 pcs screws (
Clear the debris of the surface and the inside of the injection nozzle.
NOTE :
It is recommended that this heater painted body components from the
emitter down are periodically protected with a coat of automobile wax.
If repainting is necessary, paint only the post and gas cylinder housing.
Never paint the reflector, combustion assembly, or instruction plate on post.
Keep exterior surfaces clean:
Use warm soapy water for cleaning. Never use flammable of
corrosive cleaning agents.
While washing your unit, be sure to keep the area around the combustion
assembly dry at all times. If the gas control is exposed to water in any way,
do NOT try to use it. It must be replaced.
O W "
) at the bottom of control cylinder.
3
WARNING
FOR YOUR SAFETY :
DO NOT touch or move heater for at least 45
minutes after use.
Allow all burner elements to cool before
touching.
NOTE
In a salt-air environment (such as near an
ocean). corrosion occurs more quickly than
normal. Frequently check for corroded areas
and repair them promptly.
NOTE
Wait until heater is cool before covering.
)
1
1
)
2
13
STORAGE/CLEANING STORAGE/CLEANING
2
3
Emitter
Screen
Lower
Cone
Cylinder
Control
Cylinder