MSI MS- 9130 v1.x User Manual page 53

Onboard Serial Port 1/2
These items specify the base I/O port address and IRQ for the onboard
Serial Port A (COM A)/Serial Port B (COM B). Selecting Auto allows
BIOS to automatically determine the correct base I/O port address. Settings:
Disabled, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto.
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port.
Settings: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
This item selects the operating mode for the parallel port: Normal, SPP,
EPP, ECP, or ECP+EPP.
SPP:
EPP:
ECP:
ECP + EPP:
Normal:
EPP Mode Select
This item selects the EPP mode. Settings: EPP1.9, EPP1.7.
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard
parallel port with the ECP feature. After selecting it, the following message
will appear: "ECP Mode Use DMA." At this time, the user can choose
between DMA channel 3 or 1.
Init Display First
This item specifies which VGA card is your primary graphics adapter. Settings:
PCI Slot, AGP.
Power Status Led
This item sets how the system uses Power LED on the case to indicate the
suspend/sleep state. Settings are:
Single
Dual
Standard Parallel Port
Enhanced Parallel Port
Extended Capability Port
Extended Capability Port + Enhanced Parallel Port
Standard Parallel Port + Bi-Directional Mode.
The Power LED blinks to indicate the suspend/sleep
state.
The Power LED changes its color to indicate the sus-
pend/sleep state.
BIOS Setup
3-17