MSI MS- 9130 v1.x User Manual page 45

1st/2nd/3rd Boot Device
The items allow you to set the sequence of boot devices where BIOS attempts
to load the disk operating system. The settings are:
Floppy
LS120
Hard Disk
CDROM
ZIP100
USB-FDD
USB-ZIP
USB-CDROM
Legacy LAN
Disabled
Boot Other Device
Setting the option to Enabled allows the system to try to boot from other
device if the system fails to boot from the 1st/2nd/3rd boot device.
Boot Up NumLock Status
Toggle between On or Off to control the state of the NumLock key when the
system boots. When toggled On, the numeric keypad generates numbers in-
stead of controlling cursor operations.
Security Option
This specifies the type of BIOS password protection that is implemented.
Settings are described below:
Option Description
Setup The password prompt appears only when end users try to
run Setup.
System A password prompt appears every time when the com-
puter is powered on or when end users try to run Setup.
The system will boot from floppy drive.
The system will boot from LS-120 drive.
The system will boot from the hard disk.
The system will boot from the CD ROM.
The system will boot from the ATAPI ZIP drive.
The system will boot from the USB-interface
floppy drive.
The system will boot from the USB-interface ZIP
drive.
The system will boot from the USB-interface CD-
ROM.
The system will boot from the Network drive.
Disable this sequence.
BIOS Setup
3-9